Haakaa Supplemental Feeding Tube

Many mums and their babies experience feeding issues – including latching problems, low milk supply, or maybe little ones that need a little extra nourishment or help to learn how to feed. The Supplemental Feeding Tube Set helps you to overcome some of these common issues by connecting a bottle of supplemented milk to your breast via a tube, delivering a constant and controllable flow of milk to baby at the breast. Through the use of the Silicone Feeding Tube, both mother and baby can experience the natural physical sensation of breastfeeding, while encouraging mom’s supply and ensuring that baby receives adequate nutrition.

The flow of milk can be carefully controlled by adjusting the height of the bottle or by using the flow controller for a more consistent rate. Our Silicone Feeding Tube works seamlessly with our Haakaa Gen. 3 Silicone Baby Bottles and X-Shaped Variable Flow Nipples (sold separately) but can also be used with any other baby bottle equipped with an X-shaped variable flow teat. Simply place the bottle in an elevated position higher than the end of the outlet tube to start the flow of milk.

Contents: 1 x Inlet Tube, 1 x Outlet Tube, 1 x Tube Adapter, 1 x Flow Controller, 1 x Cleaning Brush, 1 x Medical Tape, 1 x Carry Case

Features

• Made with food grade silicone and polyformaldehyde.
• Flow controller provides a consistent flow of liquid.
• Provides added nutrition to the baby, while also giving mum and baby the sensation of breastfeeding.
• Long and slim tube for inconspicuous and discreet use.
• Additional flow control when used with squeezable Haakaa Gen. 3 bottles.
• BPA, PVC and phthalate-free.

Directions

1. Insert both the inlet and outlet tubes into ends of the tube adapter. Thread the end of the outlet tube through the flow controller.
2. Push the thick inlet tube down through the X-shaped opening on the Variable Flow Teat or a regular teat with a slit cut in it and pull it through until it is long enough to reach the milk in the bottle. Attach the teat to the bottle.
3. Place the end of the thin outlet tube so that the end of the tube aligns with the end of your nipple and secure its position on your breast with the tape.
4. Latch your baby to your nipple ensuring that the tube remains in position.
5. If using the Haakaa Gen. 3 Baby Bottle, squeeze the silicone bottle body to control the flow of milk. Increase pressure on the bottle to increase the speed that milk flows or reduce pressure to slow it down.
6. If using another baby bottle with a modified teat, simply place the bottle in an elevated position higher than the end of the outlet tube to start the flow of milk. The bottle can be positioned between your breasts.
7. You can also use the flow controller to manager the speed that milk flows, adjusting to suit your child.

Cleaning and Care
Clean after each use. Use the included cleaning brush to scrub the inside of the tube before rinsing with hot water. For easier operation, feed the brush through the tube by the handle and pull through. We strongly recommend cleaning and sterilizing this product with any steam sterilizing system, or by boiling in water for 2-3 minutes. Do not use any bleach-based agents or sterilizing tablets to clean this product. Do not use a UV sterilizer to clean this product as it may impact its lifespan. 

Caution: Check product condition before each use. Immediately discontinue use and replace if this product shows any signs of damage. Do not store near any sharp objects. Only soft bristle brushes or soft sponges should be used to clean this product, as hard scourers may scratch the surface. Exposure to detergent may make the silicone in this product appear cloudy. This product is not a toy. Do not use this product for anything other than its intended use. Store product in a cool, dry place and avoid direct sunlight. Adult supervision is required. 

Note: We recommend consulting with your midwife, a lactation consultant or medical specialist if you have any concerns with breastfeeding.